Utica MGB100 Provozní pokyny Strana 16
- Strana / 28
- Tabulka s obsahem
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
LIGHTING PROCEDURE FOR BOILERLIGHTING PROCEDURE FOR BOILER
LIGHTING PROCEDURE FOR BOILERLIGHTING PROCEDURE FOR BOILER
LIGHTING PROCEDURE FOR BOILER
WITH CONTINUOUS PILWITH CONTINUOUS PIL
WITH CONTINUOUS PILWITH CONTINUOUS PIL
WITH CONTINUOUS PIL
OO
OO
O
TT
TT
T
FOR YOUR SAFETY READ BEFORE LIGHTINGFOR YOUR SAFETY READ BEFORE LIGHTING
FOR YOUR SAFETY READ BEFORE LIGHTINGFOR YOUR SAFETY READ BEFORE LIGHTING
FOR YOUR SAFETY READ BEFORE LIGHTING
A. Read the warning at the beginning of the LIGHTING INSTRUCTIONS. (Page 13)
B. This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow
these instructions exactly.
C. Before lighting, smell all around the appliance area for gas. Be sure to smell next to
the floor because some gas is heavier than air and will settle on the floor. See page 14 for
WHAT TO DO IF YOU SMELL GAS.
D. Use only your hand to push in or turn gas control knob or reset button. Never use tools.
If the knob or reset button will not push in or turn by hand, don’t try to repair it, call a qualified
service technician. Force or attempted repair may result in a fire or explosion.
E. Do not use this appliance if any part has been under water. Immediately call a qualified
service technician to inspect the appliance and to replace any part of the control system and
any gas control which has been under water.
LIGHTING INSTRUCTIONS FORLIGHTING INSTRUCTIONS FOR
LIGHTING INSTRUCTIONS FORLIGHTING INSTRUCTIONS FOR
LIGHTING INSTRUCTIONS FOR
CONTINUOUS PILCONTINUOUS PIL
CONTINUOUS PILCONTINUOUS PIL
CONTINUOUS PIL
OO
OO
O
TT
TT
T
1.
STOP!STOP!
STOP!STOP!
STOP! Read the safety information at the beginning of these instructions.
2. Set the thermostat to the lowest setting.
3. Turn off all electric power to the appliance.
4. Remove access panel and burner door.
5. Turn gas control knob clockwise to "OFF". See figure's 15 & 16 below.
NOTE #1: Some gas control knobs cannot be turned from "PILOT" to "OFF" unless
knob is pushed in slightly.
DO NOT FORCE.DO NOT FORCE.
DO NOT FORCE.DO NOT FORCE.
DO NOT FORCE.
6. Wait (5) minutes to clear out any gas. If you then smell gas, STOP! Follow “What To
Do If You Smell Gas”, on page 14. If you don't smell gas, go to the next step.
7. Find pilot. Follow metal tube from gas control. Depending on the model of the boiler,
pilot is either mounted on the base or on one of the burner tubes.
8. Turn gas control knob counterclockwise to "PILOT".
PAGE 15
FIGURE 15
FIGURE 16
- GAS FIRED BOILERS 1
- FOR FORCED HOT WATER 1
- Tested for 100 lbs 2
- ASME Working 2
- Pressure 2
- FIGURE 2 6
- FIGURE 1 6
- FIGURE 3 FIGURE 4 7
- FIGURE 7 8
- FIGURE 6 8
- FIGURE 5 8
- FIGURE 9 9
- FIGURE 8 9
- FIGURE 10 10
- FIGURE 11 12
- FIGURE 12 12
- CONNECTING GAS SERVICE 13
- FIGURE 14 15
- FIGURE 15 16
- FIGURE 16 16
- FIGURE 17 FIGURE 18 18
- FIGURE 19 19
- FIGURE 20 19
- FIGURE 22 20
- FIGURE 21 20
- FIGURE 23 21
- FIGURE 25 22
- FIGURE 24 22
- FIGURE 26 23
- FIGURE 27 24
- FIGURE 28 25
- FIGURE 29 26
- PAGE 27 REV 14.1, May 2004 28
Fender Příslušenství pro hudbu uživatelské příručky
Začínající na G
Komentáře k této Příručce